Suchergebnisse

yes 330mm

I have made some.they are no longer availble from schippers. gruss alan Danemark

ok I can see its using a steady program.some of the 4 connectors on the right is connected.if they were all cut,it was using the programmeble program,which sometimes is lost.So I dont think the program is the problem. Call Fleischmann first,because on their web it says they dont repair it...

ahh,ok.then the fuse is ok.so something else is wrong with the charger. But the fuse is the brown round thing behind the 343 plug

When the blower doesnt run shortly,when powered on,it sounds like the small fuse is defective. If Fleiscmann cannot help you,maybe I can repair it for you.I dont think they repair these chargers anymore. Alan Danemark

Thats right Werner,BUT that is for only around 25km/h,and has very slow acceleration.Its meant for moped speed.But on the newest version of the strombegrenzer this doesnt work.you need the version older. Alan

Hello Peter and Sasha adjusting the strombegrenzer,will not reduce the speed.ONLY the acceleration. You need to put in a resistor in the compund circuit if its a TT-motor.If its a Perm motor you need to change the sprockets. Alan Danemark

Hi Brian I dont think its the curtis.More probably the microswitch at the speederpedal.This is a common problem.DONT measure it,change it,and with a good quality,not a cheap one. It could also be another problem,depending on which cityel you have.Try this.If you press the speeder a bit,and it...

Hello Sven I have heard of one owner,whot the kronrohr in the freezer,to take off the sprocket and kugellager. I have not tried,as I have a hydralicpump gruss alan

I have bad experience with Curtis look alike controllers.They are NOT calibrated,so often they give more current than you program them with.so if you program it to 275amp,they might give 350amp. alan

I will bring one to the tref Alan

I make new sensors that fit directly in the holder,with cable.And LED in the back,to see if it works. Price:30euro

I have the lagerbolzen for the swingarm alan danemark

I can repair the curtis.I need the defective one first to see if its repaireble.Sometimes there has been fire inside. If ok,then you will get an exchange curtis,that has been repaird. Alan Danemark

does the relays in the back klick,when you presse the speederpedal? If not it could be the speederswitch,or the controller. I dont think the motor,they seldom die. Alan danemark

Dores the MEG charger,when used with Lead acid batteries,start a new charging,after it has finished charging. The Thiesen charger does that after I think 20hrs,and the old trafo-charger has a float voltage. But if the MEG charger does not start again,then if you dont use the cityel for a long...

I have made new PCB´s for the cell and the relay,BUT without the Uprocessor.That must be ok in the old PCB,and moved over to these new PCB

Hello I had one ellert,which died with this fault.The hole front wheel came up inside the ellert. I have a picture,but could not load it in this site.But maybe with glassfiber inside and outside,it can be repaird. Richards ellert,in England only had problem with the steering.no karrosserie...

I ahve the tool.will ake a drawing with measures this week. Alan