Suchergebnisse

Hallo markus I sell exchange brakeshoes with new lining on. gruss alan danemark

Kommen her.sorry

Hello Patrick.' I paid 325euro on the 10-4-25.Please confirm. alan.lyman@mail.dk gruss Alan

Yes I have new sensor in stock.The original one was speciel made for city el.the first danish one for the mini el,also had a thermosensor,for the kapamesser inside. Mine also have a LED in the back,for easy adjustment. price is 30eure+shipping gruss Alan

I dont think these work with CPOMPOUND motors,such as Thrige.I had one here in danemark,with same problem.I exchanged it for him with a refurbished old curtis.Also they dont like PERM motors or permagnet motors,as they generate strom when running freewheel,and the clone curtis sees that as a...

Hello Filip I can deliver refurbished brakeshoes.only need the old ones back. kontakt me offline:alan.lyman()mail.dk

It depends on which charger you have. Thiesen=min spannung under 28v(maybe defective cells) MEG charger does not have 5blink,but 4blink =charger has been disconnected from batteries.Its normal it blinks 4times,without meaning anything.it will still charge. alan

I have single relay ALBRIGHT /36v+48v in stock.price is:115euro+shipping gruss Alan Danemark

the resistor is: 8,2ohm smd 1206 size alan

yes 330mm

I have made some.they are no longer availble from schippers. gruss alan Danemark

ok I can see its using a steady program.some of the 4 connectors on the right is connected.if they were all cut,it was using the programmeble program,which sometimes is lost.So I dont think the program is the problem. Call Fleischmann first,because on their web it says they dont repair it...

ahh,ok.then the fuse is ok.so something else is wrong with the charger. But the fuse is the brown round thing behind the 343 plug

When the blower doesnt run shortly,when powered on,it sounds like the small fuse is defective. If Fleiscmann cannot help you,maybe I can repair it for you.I dont think they repair these chargers anymore. Alan Danemark

Thats right Werner,BUT that is for only around 25km/h,and has very slow acceleration.Its meant for moped speed.But on the newest version of the strombegrenzer this doesnt work.you need the version older. Alan

Hello Peter and Sasha adjusting the strombegrenzer,will not reduce the speed.ONLY the acceleration. You need to put in a resistor in the compund circuit if its a TT-motor.If its a Perm motor you need to change the sprockets. Alan Danemark

Hi Brian I dont think its the curtis.More probably the microswitch at the speederpedal.This is a common problem.DONT measure it,change it,and with a good quality,not a cheap one. It could also be another problem,depending on which cityel you have.Try this.If you press the speeder a bit,and it...

Hello Sven I have heard of one owner,whot the kronrohr in the freezer,to take off the sprocket and kugellager. I have not tried,as I have a hydralicpump gruss alan

I have bad experience with Curtis look alike controllers.They are NOT calibrated,so often they give more current than you program them with.so if you program it to 275amp,they might give 350amp. alan